#Impala 2004 power steering fluid image how to
#Impala 2004 power steering fluid image install

Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Replacement fasteners must be the correct part number for that application. Notice: Use the correct fastener in the correct location.

#Impala 2004 power steering fluid image install

Install the power steering pressure line (1) to the clamps on the power steering gear. Install the power steering pressure line (1) to the vehicle. Remove the power steering pressure line (1) from the vehicle. Remove the power steering pressure line (1) from the clamps on the power steering gear. Refer to Lifting and Jacking the Vehicle in General Information. Access the line from the engine compartment, between the rocker arm cover and the front of the dash mat. Remove the power steering line from the power steering gear. The power steering pressure line is the lower line at the power steering gear. Remove the power steering pressure line from the power steering lines retaining bracket on the engine. Remove the power steering pressure line from the power steering pump. Power steering pressure pipe/hose replacement (3.4L). If this happens, disconnect the other hose.Here is what I have from GM service information.

If you disconnect the wrong hose, when you turn the wheel, the unplugged hose will suck fluid instead of discharging it. Warning! Usually, these hoses do not have any marks so you will not be able to differentiate the return hose from the high pressure hose. Unplug the return hose (it is usually the thinner one or the one that is plugged sideways), and then place its end in the container. The reservoir has two hoses: The low pressure or return hose, and the high pressure hose. Then, you need to extract the rest of the fluid that sill remains there. Remove the power steering fluid reservoir and use a syringe to take most of the old fluid out.ģ. This step is not mandatory, but it makes this process easier.Ģ. Lift both front wheels with the jack, so that there are a few centimeters between them and the floor. To change this fluid, you must follow these steps:ġ. A jack (it is not mandatory, but it makes this task easier to perform).A rubber cap or something you can use to cover the reservoir mouth.A container where to put the used fluid.A syringe or a pipette to remove the used fluid.You can see which one you need in this guide.

The recommended power steering fluid for your car.

To replace it, you will need these elements: If everything is working properly but its level is low, refill it until it reaches the mark you don’t need to replace it completely.

You will be able to notice this deterioration because it will be dark and dull. As time goes on, this fluid gets deteriorated. Take into account that you should replace it only if there is a problem with the power steering system: for example, if it is making weird noises or it is hard to turn your car’s wheels. To do so, you must make sure that your car is cold and its engine is off. In short: Changing the power steering fluid is easy.

#Impala 2004 power steering fluid image how to

How to change the power steering fluid of your Impala?